#Star wars clone rifle torrent

Their primary weapon, the DC-17m Repeating Blaster Rifle, has a high rate of fire and deals a fair amount of damage, but must be reloaded after a short period of time instead of put on cooldown. Though the DC-15S, DC-15A, and many other clone basters are based upon the German MG34.Įxplore all of Wookieepedia's images for this article subject.The Clone Commando is a tank that can withstand tons of damage from enemies while outputting similar amounts against them. The DC-15S is the supposed precursor to the E-11 which came after it. The weapon strongly resembles the E-11 blaster rifle which is based on the British Sterling L2A3 submachine gun. In the video games Star Wars: Battlefront and Star Wars: Battlefront II, the DC-15S is used as a blaster pistol by clone troopers. It is also misidentified as such in Star Wars: Battles for the Galaxy. In Death Trap, Boba Fett mistakenly identifies a DC-15S as a DC-15A.

The design of the DC-15S would later be enhanced by BlasTech for the introduction of the E-11 blaster rifle, commonly known as the ' stormtrooper rifle'.Ĭlone troopers stationed in close quarters environments would often use the weapon, such as the Kamino guards and the battles inside ships, probably to avoid damage to the surrounding areas. The weapon was also carried by the bodyguards of the Pantoran Chairman Chi Cho during their border dispute on Orto Plutonia with the native species, the Talz. The weapon was used by the Christophsian resistance against the invading Separatists on their planet of Christophsis, however, all their attempts at fighting of the droid army failed until they were reinforced by the Republic. The DC-15S became more common during the later period of the war.Ĭhristophsian resistance defending their home. It could be set to a high pressure rapid-fire, as demonstrated by a member of the 212th Battalion on Utapau. While the longer range of the more powerful DC-15A blaster rifle was often preferable to the DC-15S, its higher rate of fire and shorter build made it useful in combat, particularly in close-quarters battles. While its popularity would rise and decline, it was used extensively throughout the Clone Wars as both a primary and secondary weapon.

It became increasingly common just before the Battle of Teth, though its popularity did decrease after the Battle of Ryloth. The DC-15S was widely used by clone troopers during the Clone Wars, though most notably in the conflict's final days. Please improve it in any way that you see fit, and remove this notice once the article section is more complete.Ī clone cold assault trooper firing a DC-15S It is requested that this article section be expanded. Additionally, the blaster had a stun setting, as shown by Boba Fett when he attacked CT-1477 on the Endurance. This famous clone blaster was often used by Commander Cody of the 212th Attack Battalion.

#Star wars clone rifle torrent

Captain Rex and the Torrent detachment of the 501st Legion utilized this capability most noticeably during the Battle of Teth, using them to scale the sheer cliff below their objective. The blaster could also fire a grappling cable which was attached to the butt of the folded stock, requiring the stock to be folded when using the cable. This gun was known to be dual-wielded and sometimes held as a pistol. They were extremely powerful weapons, especially in the hands of experienced clone troopers, and were more than capable of piercing heavy armor. Instead, the cartridges were replaced by the trooper in his spare time, by opening a hatch near the back of the weapon, popping out the old cartridge, inserting the new one, and closing the hatch. Many troops carried spare energizer packs on them, but due to the fragility and difficulty of replacing the tibanna cartridges in combat, few troops carried more than the one in their gun on them. The gas cartridges always lasted for around 500 shots, due to the fact the DC-15S had no power settings, except for the nonlethal stun setting, while the power magazines lasted around 50. DC-15 blasters fired charged plasma bolts, with tibanna cartridges activated by power magazines (replaced by sliding them out of the side of the gun and inserting a new one) and projected down a magnetic accelerating barrel. This blaster was not a true repeating blaster, but it could handle braced firing much better than its larger cousin, with more accuracy and less chance of overheating. The length of the trigger pull determined the firing setting (semiautomatic or automatic). The DC-15S also featured a folding stock for enhanced aiming with braced firing. Smaller in scale than the DC-15A blaster rifle, the DC-15S blaster lacked its larger cousin's range, but was easier to handle than its bulkier cousin with a higher rate of fire.